Ravenna city walls, 1512

Last year at Historicon, I did the Battle of Bicocca 1522. The Battle had quite a lot of scenery required for the action including the field defenses and the villa Bicocca with the large Italian Gardens. You can see a report on the Battle here. This year I will be doing the Battle of Ravenna. The problem that I have is that the battlefield itself is limited in terms of scenery, I want to make the table look as impressive as possible for Historicon. The Battle was fought when the Spanish and Papal troops came to relieve the city of Ravenna from siege by the French. Although the city played no part in the battle, the Ravenna city walls were a backdrop to the battle.

Models for the walls

The solution was obvious, I needed to make the city walls of Ravenna as a backdrop to the battle. After searching the internet for a suitable kit to represent the Italian style city walls I came across the range by Tabletop World from Croatia. They are walls originally made for fantasy, but by selecting the right models from their range I was able to get a great looking wall. At first I was initially nervous about ordering from Croatia, so I placed a small order. It arrived without issue, and the company was a joy to deal with; so I then placed a larger order for the rest of the parts.

After washing the parts with soapy water, I spray primed them in black. After a couple of days I them sprayed them brown and sealed them with a coat of matte varnish. I then used a beige paint to paint the walls and then used various powders for different tones and weathering effects.

The base

Once the base painting had been done I wanted to check the layout with some city buildings. The total area is about 2′ x 4′. I didn’t want the buildings to be taller than the city walls, so I raised the walls with 2″ of foam. This meant that only the church tower could be seen rising above the walls, similar to the woodcut.

2″ foam used to raise the walls.

I kept the foam pieces at a maximum of 24″ in length so that they would be transportable. This decision meant that I needed three foam base pieces. Once the layout had been done I then shaped the base foam using a cheap woodland scenics hot-wire foam cutter. I then painted and sealed the foam with my usual mixture of brown paint, Elmers glue and model railroad ballast.

Blending the base into the terrain

I then needed to make sure that the base would blend with my terrain mats rather than just sit on them. So I cut and glued some terrain mat pieces to the edge of the foam.

Some terrain mat glued to the foam to blend in to the terrain mat.

This technique is the one that I used for the field defenses at Bicocca and it worked well in that case. However, it didn’t seem quite right in this situation, so I folded the terrain mat pieces underneath and glued them. It seemed to work much better.

The next stage was to blend in the terrain mat to the foam at the top, so I made up some more of my paint/elmers/ballast mixture. After shaving the fur mat on the top I proceeded to apply the mixture to blend things in.

Finishing and detailing.

The last stage was to add various woodland scenic flocks, grasses and bushes.

That meant that the outside was finished. For inside the city I was planning to use some cobblestone mats (from Novus designs) for the city to sit on. This still meant that I needed to finish the foam on the inside. To provide a pleasing transition I made some earth retaining walls from balsa and then weathered them.

The city is now complete for Historicon, all I have to do now is finish about 60 Landsknechts. Here are a couple more views of the Ravenna city walls and buildings.